Haltech iC-7 to LS2 LS3 (GEN 4 LS) 7" Digital Colour Display Plug in Kit
MUCH MORE THAN JUST AN OBD2 DASH
Compatible with the following Australian Delivered Engines:
- LS3, L98, L77, L76, LSA, Late LS2 (e38 ECM)
Designed to be used with the FACTORY GM ECM (ECU)
Includes Digital Display, CAN Module, OBD2 Cable
Display Includes the Following Parameters:
- Speedo - With trip meter & ODO
- Tacho - With LED Shift Lights
- MIL (Malfunction Indication Lamp or Engine Light) - A Requirement for Engineering
- Battery Light (Alternator Failure)
- Voltage - With Programmed Warnings
- Gear Position and Trans Temp (6L80e Only)
- Oil Pressure - With Warnings & Alarms
- Water Temp - With Warnings & Alarms
- Oil Temp (If using Factory Sump Sensor)
- MAP/Boost Pressure
- Fuel Level (Using in tank Sender)
- Cruise Control Indicators
- Throttle Position
- O2 AFR (estimate)
- Inputs for Indicators, High Beam & Park Lights
- Inputs for 4x4 Light, Locker Lights, Spotlight Pilot Lamps, Nitrous Active Light, Transbrake Light, Door Ajar Light, Seatbelt Light
Features & Inclusions:
- Custom Pre Programmed Dash, with Warnings, Shift Lights & Alarms Pre-Set
- GM to Haltech CANBUS Translator Module Pre Wired
- ZERO LAG - Kit uses outputs from PCM for seamless refresh rate
- Comprehensive, Plain English instructions
- Aftersales Support, here to help you install
We are an official Haltech dealer and are extremely happy to be bringing this innovative kit to the market!
PLEASE NOTE - GPS Speed Modules are available if you do not have an alternative speed input available.
Please allow 3-4 weeks for shipment as these kits are CUSTOM and MADE TO ORDER.
Please email or call us with any special requests in regards to programming or sensors.